Ψεκαστήρας ομίχλης ψύξης νερού 6/9/12/15/18m υπαίθρια ομίχλη υδροσωλήνων κήπων αυλών για άρδευση ποτίσματος Patio θερμοκηπίων

1. The fine atomizing nozzle is made of brass with stainless steel core guide vanes inside. The liquid forms a centrifugal vortex in the guide vanes, and fine hollow mist particles are ejected from the nozzle holes, which can be widely used in plant humidification and cooling, disinfection, dust reduction, landscaping, salt spray test and other artificial fog, the aperture is 0.3mm. 2. This series of nozzles do not need air assistance, the system is simple, the spray point is fine, the atomization is sufficient, energy saving and water saving, low cost and good effect. 3. The stainless steel spray plate is processed by advanced forging and pressing process, and has strong durability. 4. This nozzle can completely use the pressure of tap water for atomization. It is better to use a high-pressure water pump. Installation steps: 1. It is recommended to install the atomization system at a height of 2.5m-3m. 2. Connect the adapter to the faucet. 3. Turn on the faucet to clean the system for 1 minute to clean the system and remove impurities. 4. Screw the spray nozzles onto the tee fittings, except for the very end one. 5. Turn on the faucet to clean the system for 2 minutes to ensure the system is completely cleaned. 6. Turn off the water and install the last nozzle onto the fitting, using the end plug. 7. Secure the atomizing tube with the cable tie saddle clip provided. 8. Turn on the faucet until the sprayer works and enjoy the cooling misting system. 9. When the atomization system is not used for a long time, close the nozzle and keep it dry and clean. 10. Package:Atomizer x 1 set Note: 1. Due to light and screen differences, the color of the product may be slightly different from the picture. 2. Please allow 0.5-2cm difference due to manual measurement.